VISAM Support Forum
VTP Panel can not boot - Druckversion

+- VISAM Support Forum (https://www.visam.com/forum)
+-- Forum: VBASE / VisAM HMI/SCADA (https://www.visam.com/forum/forumdisplay.php?fid=1)
+--- Forum: VTP - VISAM Touch Panel (https://www.visam.com/forum/forumdisplay.php?fid=19)
+--- Thema: VTP Panel can not boot (/showthread.php?tid=787)



VTP Panel can not boot - akivanc2 - 17.10.2022

Hello all,

After Power on the  VTP-BC120-0 Vbase Panel during booting, there is a message says CMOS Checksum error. AAfter press the F1 key from n Keyboard , it is continnue to processing. Visam starts to opening but finally Screen becomes dark.

Any idea what to do?


RE: VTP Panel can not boot - R.Best - 18.10.2022

(17.10.2022, 13:45)akivanc2 schrieb: Hello all,

After Power on the  VTP-BC120-0 Vbase Panel during booting, there is a message says CMOS Checksum error. AAfter press the F1 key from n Keyboard , it is continnue to processing. Visam starts to opening but finally Screen becomes dark.

Any idea what to do?

Hi akivanc2,
the CMOS checksum error refers to an empty BIOS battery. So you can just replace it with a new one. Only make sure that the new battery has the same specifications as the old one.
After you changed the battery, you have to connect a keyboard and press the "Del" to enter the BIOS and select Windows CE 7 as mentioned in this screenshot.
[Bild: 111.png]
If you dont have the means to change the BIOS battery, you have to go through this selection after every restart.
If you dont want to do this replacement yourself, you can also just fill out the RMA formular from our site (https://www.visam.de/rma.php) and send the device to us.

Regards
Roman Best


RE: VTP Panel can not boot - akivanc2 - 19.10.2022

Vielen Dank. Es ist Ok.